LEDRLB145XW6-XQ-2.PDF datasheet pdf

Datasheet Lighting for use with Vision Systems • Four high-intensity, visible wavelengths, plus IR • The following array lengths are available: 145 mm (5.7 in) 290 mm (11.4 in) 435 mm (17.7 in) 580 mm (22.8 in) 870 mm (34.2 in) 1160 mm (45.6 in) • High-power, solid-state LED array; continuous or strobed operation is selectable via sensor software (P4 models) or via hookup • Optically isolated strobe signal • Selectable Active High or Active Low strobe option • Maintenance-free, rugged construction • Built-in constant current regulation • Very even light pattern • Can also be used as a highly diffused area light • Diffused backlight for any Vision System Model Key Light Source LED Color Linear Array Array LengthHousingWindow Material Relative Intensity Intensity ControlConnector LEDRLB145XW6-XQ R = Red W = White B = Blue G = Green I = IR 145 mm (5.7 in) 290 mm (11.4 in) 435 mm (17.7 in) 580 mm (22.8 in) 870 mm (34.2 in) 1160 mm (45.6 in) X = IP50W = White PlasticX = Not AdjustableQ = QD Wiring Wire Purpose Cable Wire Color 1 Wire Connections PresencePLUS ® Pro Controller Terminal Block Power WiresBrown (1)+24 V dcPin 01 2 Blue (3)commonPin 02 Strobe Polarity ControlGray (5)Active Low: open Pin 02 or open Active High: connect to common (Blue wire) Strobe Voltage WiresWhite (2)Active Low: 0 V dc = ON+5 V dc to 24 V dc = OFFPin 04 Active High: 0 V dc = OFF+5 V dc to 24 V dc = ON Black (4)Strobe commonPin 02 (1) +24V dc (3) Common (5)Active High/Active Low (4) Strobe Common (2) Strobe (+/0) Figure 1. Pinouts for Mating Cable Note: Connection to earth ground recommended. 1 For Banner-supplied wire. 2 When connecting the light to a PresencePLUS ® Pro controller terminal block, the controller supply must be 24 V dc ± 10%. High-Power Unsealed Linear Backlights Original Document 166314 Rev. E 13 March 2019 166314